The BlindTransfer command is used to connect two phones together. If
the connection is established, the phone which connected the phones together will
leave the conversation. You can see how to use this command in a HTTP request and what
HTTP response you will get from the phone system (Figure 1).
Figure 1 - BlindTransfer Application/XML example
string value, BlindTransfer
Specifies the type of the HTTP API command.
string value, e.g. H2Wwb
The call ID of the call you want to run the BlindTransfer command on.
string value (caller or callee)
The party member who will make the transfer.
int value, e.g. 1001
The phone number you want to transfer the party member to.
Step 1: Make a call between two extensions. Use ListActiveCalls command to find the call ID of the call you want to blindtransfer. You can find the CallId in the response, between one of the <CallId></CallId> nodes.
Step 2: Initiate a BlindTransfer using a HTTP request as seen in the picture above. Paste the call ID you found in Step 1 in the CallId parameter of the request.
The project was established
with the European Union
subsidized by the European
Regional Development Fund